CARBON REMOVER______25L
আমাদের যে কোন পণ্য অর্ডার করতে কল বা WhatsApp করুন
Unitor™ carbon remover ™ is a heavy duty solvent based cleaner ideal for removal of stubborn carbon deposits.
Product information
Unitor™ carbon remover ™ is a powerful non-corrosive solvent for quick break down carbon deposits and very economical in use.
Features
- Quickly dissolves deposits containing carbon, resins or varnishes
- Non flammable
- Removes carbon type deposits from burner tips, fuel injectors and all components fouled by carbon, resin or varnishes
- Cleans oil side of fuel heaters, oil coolers, etc.
- Removes carbon based deposits from fuel and lube oil filters
- Can use for cleaning of: – Pistons – Piston rings – Valve cages
Benefits
- Simple and economical to use
- Eliminates the need for hard scraping
Specification
General
| Invent Hazard Material (IMO/EU) classification | C-49 |
|---|
Physical properties
| Appearance | Clear brown |
|---|---|
| Density [g/ml] | 0,99 – 1,00 |
| Flash Point [°C] | Above 61 |
| Form | Liquid |
Technical data
| Not Compatible | Avoid natural and synthetic rubber |
|---|
Directions for use
Soak Method
This method is an effective way of cleaning deposits from components and machine parts. In order to reduce the evaporation of Unitor™ Carbon Remover™ both on the pure product as well as on its emulsions, a skin is formed when exposed to air.
The items for cleaning are submerged into the active solvent. Small components can use for a wire basket.Immersion time will depend upon the nature of the deposits to be removed. Light deposits will remove in 1 hour, whereas heavily oxidised deposits might need longer time.
The components should rinse thoroughly before handling.
Cleaning the Oil Side of Heat Exchangers
- Isolate the oil supply, disconnect the heat exchanger oil inlet and outlet, drain off any remaining oil.
- Connect the discharge side of Unitor™ Chemical Cleaning Unit (CCU) to the lower heat exchanger connection and fit the return to the CCU.
- Add Unitor™ carbon remover™ to the drum, product can dilute with diesel oil down to 25 % and heat, maintaining the temperature (max 50°C) throughout the cleaning operation. If heating is not available, the cleaning time will need to extend and a higher product concentration is beneficial.
- Circulate for 12 hours. When the cleaning is complete, disconnect the lower heat exchanger connection and drain.
- Connect a high pressure fresh water supply to the upper heat exchanger connection. Rinse until water runs clear.
- Disconnect, drain and dry.
Reviews
There are no reviews yet.